10
TA-S9D
SECTION 5
DIAGRAMS
5-1.
NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
B
These are omitted.
C
E
Q
Note on Printed Wiring Boards:
•
X
: parts extracted from the component side.
•
Y
: parts extracted from the conductor side.
•
f
: internal component.
•
: Pattern from the side which enables seeing.
• Indication of transistor.
Note on Schematic Diagram:
• All capacitors are in
µ
F unless otherwise noted. pF:
µµ
F
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
f
: internal component.
•
2
: nonflammable resistor.
•
5
: fusible resistor.
•
C
: panel designation.
•
A
: B+ Line.
•
B
: B– Line.
• Voltages are dc with respect to ground under no-signal
conditions.
no mark : Power on
(
) : Output is more than 1 W.
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Signal path.
F
: AUDIO
N
: MIC
• Abbreviation
AUS
: Australian model
EA
: Saudi Arabia model
KR
: Korean model
MX
: Mexican model
SP
: Singapore model
TH
: Thai model
Note: The components identified by mark
0
or dotted line
with mark
0
are critical for safety.
Replace only with part number specified.
• Circuit Boards Location
AC OUTPUT board
SURROUND AMP board
SUB TRANS board
AC INPUT board
RELAY board
FRONT AMP board
PANEL board
Summary of Contents for TA-S9D
