7
2
Overview of the SRX-series Projectors
2-3. Controls, indicators, and connectors
Front/Top
Left side/Rear
1
Remote Commander detector (front)
2
Upper side ventilation holes (intake)
3
Upper side ventilation holes (exhaust)
4
Adjusters: Used to keep the projector level if it is
installed on an uneven surface.
5
Lens cover
6
Lens mount adaptor
7
Carrying handle (there is another handle on the
rear side.)
8
Front/right side ventilation holes (intake)
1
Cooling unit: A cooling fan and the two lamp
houses are installed here.
2
Upper/rear side ventilation holes (exhaust)
3
Remote controller detector (rear)
4
Power switch: Upper is ON, and lower is OFF.
5
AC IN terminal board: Connect the AC power cord
with three wires (not supplied).
6
STATUS MESSAGE window: Displays error
messages.
7
STATUS LAMP indicator:
• Red: standby mode
• Green: Power on
• This flashes for about 10 minutes after the
power is turned off using the Remote
Commander™ unit or the SRX Controller
software.
8
INTER LOCK jack (minijack): Used to connect to an
external emergency switch.
9
Ethernet connector (10Base-T/100Base-TX)
0
RS-232C connector (D-sub 9-pin, female)
qa
Input board attachment parts: Optional boards can
be installed here. The SRX-S110/S105 is equipped
with DVI-D connector and AUX connector, and
three available slots here. The SRX-R110/R105 has
four available slots here.
qs
INPUT A (DVI interface board pre-installed at the
factory)(SRX-S110/S105 only)
• DVI-D connector (24-pin DVI connector, male):
For progressive DVI signal input.
• AUX connector (24-pin DVI connector, male):
Used for input extension.
5
4
1
2
3
6
7
8
DVI-D
AUX
5
6
9
qa
3
4
2
1
7 8
0
qs
Summary of Contents for SXRD SRX-R105
Page 1: ......
Page 32: ...32 SRX series 4K Projector System Installation Guide ...
Page 33: ...33 2 Overview of the SRX series Projectors Appendix ...
Page 51: ...51 Appendix F ...
