20
Operation During a Conference
Operations Performed by the Chairman and Delegates
To listen to the original signal
Set the CH selector to ORIGINAL. The original
signal is output to the earphone. Alternatively,
disconnect the earphone. The original signal is output
to the speaker.
Note
The speaker volume is controlled from the control
unit. It cannot be adjusted from each chairman’s unit/
delegate’s unit.
Chairman’s operations
The chairman can interrupt a delegate and take
control of the conference at any time.
To take control of the conference
Press and hold down the PRIORITY button. While
the PRIORITY button is held down, the microphone
of the chairman’s unit is enabled. Also, the
microphones of the delegates’ units are disabled.
When the PRIORITY button blinks
The PRIORITY button blinks to indicate that the
interpreter has pressed his or her SLOW button to
request the speaker to speak slowly. The chairman
then presses and holds down the PRIORITY button to
instruct the speaker to speak slowly.
Operations common to both the chairman
and delegates
The chairman and delegates can both talk and listen
by using their individual unit. The operations are the
same.
To speak
Press the MIC ON/OFF button of the unit.
The button indicator and the microphone indicator
light. The microphone is enabled.
When the MIC ON/OFF button indicator and
microphone indicator blink (delegate’s unit)
The microphone mode is set such that only five
person can speak at any one time. Currently, the
microphones of five units are already turned on. In
this case, the indicators blink for about 3 seconds,
then go out.
Note
When a delegate’s microphone is enabled, the volume
level of his or her earphone is automatically reduced.
When a delegate is listening through the speaker, the
speaker is turned off and the volume levels of the
speakers of the units on both sides of the unit are also
automatically reduced while the microphone is
enabled.
Upon finishing speaking
Upon finishing speaking, press the MIC ON/OFF
button again.
The MIC ON/OFF button indicator and the
microphone indicator go out and the microphone is
disabled.
To listen to the interpreted language
The target languages can be monitored through the
earphone. Connecting an earphone to the earphone
jack mutes the speaker of the unit.
Set the CH selector to the channel corresponding to
the desired target language. The selected target
language can be heard through the earphone.
Summary of Contents for SX-C700A
Page 4: ...4 ...
