Sony SU-WL53, Instructions Manual

Page: 10 / 96

10
(GB)
3
Adjust the angle of the Mounting
Hook Unit.
When installing the TV perpendicularly (0 degrees),
adjustment of the Mounting Hook Unit angle
(procedures
1 and 2 below) is not necessary. Make
sure that each arm base
X
is screwed in securely.
1
Remove the two screws from the arm base
X
of the
Mounting Hook Unit. Choose the holes
corresponding to the desired angle (5, 10, 15 or 20
degrees).
2 Adjust the angles of the top
Y
and bottom
Z
arm
to fit the corresponding hole, and firmly secure each
arm using the two screws removed in the previous
procedure
1 .
Notes
• Be sure to adjust the right and left arms to the same angle.
• Be careful not to pinch your fingers when adjusting the
angle of the Mounting Hook Unit.
• When using an electric screwdriver, set the torque setting
to approximately 2 N·m {20 kgf·cm}.
• Make sure that the two arm bases are screwed in securely.
Notes on the adjustment angles
• When installing TV models other than those
specified on page 2 (depending on the model's
size and dimensions, etc.), the adjustment angles
listed (0, 5, 10, 15, 20 degrees) for the arms may
be limited.
• For the available adjustment angles of the arms
when installing TV models other than those
specified on page 2, refer to the operating
instructions or the leaflet (“Installing the Wall-
Mount Bracket”) supplied with the TV.
4
Install the TV onto the Base
Bracket.
1 Latch the two upper hooks of the Mounting Hook
Unit onto the Base Bracket.
Notes
• Referring to the table on page 16, determine the
holes of the Base Bracket for latching the upper
hooks of the Mounting Hook Unit.
• Be sure that two or more persons hold the TV when
carrying it. Hold the TV securely with both hands,
and gently align it on the wall.
1