53
US
T
une
r Ope
ra
tio
ns
You can enter the frequency of a station
directly by using the numeric buttons.
1
Press D.TUNING.
2
Press the numeric buttons to enter
the frequency, then press
.
Example 1: FM 102.50 MHz
Select 1
b
0
b
2
b
5 (
b
0*)
Example 2: AM 1,350 kHz
Select 1
b
3
b
5
b
0
* Press 0 for Mexico model only.
• Adjust the direction of the AM loop
antenna (aerial) for optimum reception
upon tuning to an AM station.
• The tuning scale for direct tuning is shown
below.
* The AM tuning scale can be changed
If you cannot tune to a
station
“– – – .– – MHz” or “– – – – kHz” appears
and then the screen returns to the current
frequency.
Make sure you have entered the right
frequency. If not, repeat step 2. If you still
cannot tune to a station, the frequency may
not be in use in your area.
You can change the AM tuning scale to
either 9 kHz or 10 kHz using the buttons on
the receiver.
1
Press
?
/
1
to turn off the receiver.
2
While holding down TUNING
MODE, press
?
/
1
on the receiver.
The current AM tuning scale is
changed to 9 kHz (or 10 kHz).
To reset the scale to 10 kHz (or 9 kHz),
repeat the procedure above.
• Depending on the settings, the receiver may take
some time to change the AM tuning scale.
• All preset stations will be erased when you
change the tuning scale.
Tuning to a station
directly (Direct Tuning)
Tips
Area
FM AM
USA, Canada,
Brazil
100 kHz
10 kHz*
Mexico
50 kHz
10 kHz*
Changing the AM tuning
scale
Notes
?
/
1
TUNING MODE
