Sony STR-DH700, Service Manual

Page: 73 / 96

STR-DH700
73
HDMI RE BOARD IC3519 R5F3640DDFBR-128
Pin No. Pin Name I/O Description
1 POWER_MONITOR 1 I Power supply voltage (+9V) monitor signal input terminal for protect
2 SIRCS_IN I SIRCS signal input from the remote control receiver
3, 4 — — Not used
5 POWER_MONITOR 2 I Power supply voltage (+5.2V) monitor signal input terminal for protect
6 BYTE I Not used
7 CNVss I Not used
8, 9 — — Not used
10 RESET I System reset signal input from the reset switch “L”: reset
11 Xout O System clock output terminal (5 MHz)
12 Vss — Ground terminal
13 Xin I System clock input terminal (5 MHz)
14 Vcc1 — Power supply terminal (+3.3V)
15 NMI I Not used
16, 17 — — Not used
18 AC_CUT I AC cut on/off detection signal input terminal “L”: AC cut on
19 to 21 — — Not used
22 LED_ILLUMI O LED drive signal output terminal for illumination “H”: LED on
23, 24 — — Not used
25 iPod_ACCP I System wake up signal input terminal
26 iPod_CP_RESET O System reset signal output to the EEPROM “L”: reset
27 iPod_CP_CLK I/O Two-way serial clock bus with the EEPROM
28 iPod_CP_DATA I/O Two-way serial data bus with the EEPROM
29 TXD1/FLASH — Not used
30 RXD1/FLASH — Not used
31 CLK/FLASH — Not used
32 RTS1/FLASH — Not used
33 iPod_TX O Serial data output to the iPod connector
34 iPod_RX I Serial data input from the iPod connector
35 CLK — Not used
36 RTS — Not used
37 O_POWER O Main power on/off control signal output terminal
38 — — Not used
39 EPM — Not used
40 FL_CLK/LED_CLK O Serial data transfer clock signal output to the FL driver
41 FL_STB O Chip select signal output to the FL driver
42 FL_D_OUT/LED_DATA O Serial data output to the FL driver
43 — — Not used
44 CE — Not used
45
EEPROM_SDA/
I2C_DATA
I/O
Two-way serial data bus with the EEPROM
46
EEPROM_SCL/
I2C_CLK
I/O
Two-way serial clock bus with the EEPROM
47, 48 — — Not used
49 iPod_FLAG I Protect signal input terminal
50 iPod_LINE_MUTE O Muting on/off control signal output terminal for the iPod audio
51 iPod_VIDEO_SW O Video switch signal output terminal
52 iPod_DET I iPod detection signal input terminal
53 iPod_POWER O Power on/off control signal output terminal for the iPod
54 — — Not used
55 iPHONE DET CTL O iPhone accessory detect control signal output terminal
56 S-AIR_RST(SRC RST) O System reset signal output to the EZW-RT10 “L”: reset
57 S-AIR_POWER O Power on/off control signal output terminal for the EZW-RT10
58, 59 — — Not used
60 Vcc2 — Power supply terminal (+3.3V)
61 — — Not used
62 Vss — Ground terminal