8
Location and Function of Parts
Rear Panel
A
MASTER OUTPUT connectors
XLR-3-32 type. (balanced, reference output level: +4dBu)
No.1 pin: GND No2 pin: HOT No.3 pin: COLD
Outputs signal from MASTER OUTPUT VOLUME.
B
SEPARATE button
Pressing this button to ON (
R
) outputs only STEREO
INPUT signals or MONO INPUT signals that is set to line
level from the MASTER OUTPUT connector, output only
MONO INPUT signal that is set to microphone level from
SUB OUTPUT connector.
Used for separate to the line level output signals and
microphone signals.
C
SUB OUTPUT connectors
Phono jack (unbalanced, reference output level:
–5dBu)
Outputs a mono-mixed signal from SUB OUTPUT
VOLUME.
Outputs the same signal from two phono jacks.
D
REC OUTPUT connectors
Phono jack (unbalanced, reference output level:
–10dBu)
Outputs the signal not passing through MASTER
OUTPUT VOLUME.
E
STEREO INPUT connectors
Phono jack (unbalanced, reference output level:
–10dBu)
These are input jacks for the STEREO INPUT channel.
ST1, 2 are usually only for playback equipment. ST3 is
connected to a recording equipment wired to the REC
OUTPUT connector of this unit (SRP-X100).
F
MONO INPUT connectors
XLR-3-31 type. (balanced, reference input level LINE:
+4dBu, MIC: –60dBu)
No.1 pin: GND No.2 pin: HOT No.3 pin: COLD
This is an input connector for the MONO INPUT channel.
MONO 1/2 are for microphones but MONO 3 - 6 connect
to either microphones or line level devices.
Set the input level selector button to LINE position (
R
)
when a line level output device is connected to MONO
3 - 6.
The LCF for Fc=100Hz functions when setting the mic
level.
G
INPUT LEVEL Selector buttons
These buttons switch the MONO INPUT 3 - 4, MONO
INPUT 5 - 6 input levels according to the connected
equipment.
When these buttons is set to LINE (
R
) to a line level
(+4dBu) input and automatically assigns Ch. 3, 5 to the L
channel, and Ch. 4, 6 to the R channel.
H
+48V button
This button supplies power (+48V DC) for the condensor
microphone to MONO INPUT connectors 1 - 6.
Setting this button to ON (
R
), su48V DC to the
MONO INPUT connectors that is set to mic level.
Note
Before removing cables, or using the +48V button, always
be sure to turn the MONO INPUT button all the way down.
I
AC Inlet
Attach the supplied AC power cord here.
J
VOLTAGE SELECTOR
Set the VOLTAGE SELECTOR to your areas voltage
value. Please refer to P6.Precautions.
R
L
MASTER OUTPUT
SUB OUT
SEPARATE
REC OUT
STEREO INPUT
MONO INPUT
R
L
+
48V
120V
VOLTAGE
SELECTOR
AC IN
230V
1
2
1
2
3
3
5
6
4
ON
OFF
R
r
ON
OFF
R
r
R
L
LINE
MIC
R
r
R
L
LINE
MIC
R
r
1
9
0
34
5
6
2
8
7
