Drive Configuration Jumper
The drive configuration jumpers set your drive to be a
master or slave drive on the EIDE port. The default
position is with the jumper in the Master position.
To set the drive as a slave drive, place the jumper on
the Slave position. The third jumper is for Cable Select.
Audio Out Connector
This connector provides two channel, analog line level
audio output which may be connected to a sound card.
DC Power Inlet
The drive attaches to your PC’s standard power cable.
CD-RW Recorder User’s Guide
13
12
CD-RW Recorder User’s Guide
+5 G G +12
1
2
ST INTERFACE
POWER
DIGITAL
AUDIO
ANALOG
AUDIO
SLAVE
C
S
R G G L
0 0
S
L
M
A
39
40
MASTER
H
CABLE SELECT
GITAL
UDIO
ANALOG
AUDIO
SLAVE
C
S
R G G L
0
S
L
M
A
39
40
MASTER
HOST IN
T
CABLE SELECT
Headphone Jack/Volume Control.
To listen to an audio CD from the CD-ROM unit you may
insert a standard headphone cable into the headphone jack.
If there is a audio CD player utility installed on your PC,
you can listen to audio CDs directly from the drive. The
software functions like a typical CD player, letting you
choose tracks to play, etc. The audio can be heard through
your PC’s speakers if you connect the audio out connector
of the drive to the CD input of your sound card. The
volume control on the front panel controls headphone
volume only.
Rear Panel
EIDE Connector
The drive uses a standard 40-pin IDE connector to be
attached to an Enhanced IDE/ATAPI port on the
motherboard. See Chapter 3 which describes how to
connect your drive to your PC.
DIGITAL
AUDIO
ANALOG
AUDIO
SLAVE
C
S
R G G L
+5 G G +12
0 0
S
L
M
A
39
40
1
2
MASTER
HOST INTERFACE
POWER
CABLE SELECT
Audio Out Connector
Frame Ground
Right Signal Ground Left Signal
Pin 1
Drive Configuration Jumpers
EIDE Connector
DC Power Connector
