8
D-FS18
SECTION 4
ELECTRICAL ADJUSTMENTS
The CD section adjustments are done automatically in this set.
Precautions for Check
1. Perform check in the order given.
2. Use YEDS-18 disc (Part No.: 3-702-101-01) unless otherwise
indicated.
3. Power supply voltage requirement : DC4.5 V in DC IN jack.
(J401)
VOLUME : Minimum
AVLS
: NORM
HOLD
: OFF
Focus bias Check
Condition:
• Hold the set in horizontal state.
• Terminate TAP802 (open) by solder.
Connection:
Procedure:
1. Connect the oscilloscope to the test points TJ629 (RF) and TJ635
(GND) on the MAIN board.
2. Set a disc. (YEDS-18)
3. Press the
u
button.
4. Check the oscilloscope waveform is as shown below.
A good eye pattern means that the diamond shape (
◊
) in the
center of the waveform can be clearly distinguished.
RF Signal reference Waveform (Eye Pattern)
To watch the eye pattern, set the oscilloscope to AC range and
increase the vertical sensitivity of the oscilloscope for easy
watch-ing.
5. Stop revolving of the disc motor by pressing the
x
button.
RF level
0.4 to 0.5 Vp-p
VOLT/DIV : 100 mV (With the 10 : 1 probe in use)
TIME/DIV : 500n
s
TJ629 (RF)
TJ635 (GND)
2 K
Ω
Oscilloscope
(AC range)
[MAIN BOARD] (Side B)
CD SECTION
Summary of Contents for Sports D-FS18
