5
Rear side
a
Reset switch
When you supply power while pressing this switch with
pointed things, it is reset to the factory setting.
b
12 V (DC power input) terminal
Connects to a DC 12 V power supply.
c
U
Screws for ground wire
If you supply the power via DC 12 V or PoE, make sure to
connect the ground wire to the screw for the ground wire.
d
24 V (AC power input) terminal
Connects to the AC 24 V power supply.
Make sure to connect the ground earth to the center (
U
) of
the 3-pin terminal.
e
NETWORK (network) indicator
Lights or blinks when it is connected to the network. It is
off when it is not connected to the network.
f
LAN (network) port (RJ-45)
Perform PoE* power supply or network communication
using commercial network cables (UTP, category 5).
For details on the connection, please refer to the operating
instructions on the power supply equipment.
(*PoE: abbreviation of Power over Ethernet. PoE is
compliant with IEEE802.3af)
g
POWER (power) indicator (green)
When the power is supplied to the camera, system check is
performed within the camera.
Lights up in green, when the camera is operating normally.
h
WLAN (wireless LAN terminal)
Attach Sony USB wireless LAN module IFU-WLM3
(WLAN module, sold separately).
Use this to adjust the view angle on installation.
Notes
• Wired LAN doesn’t work when a WLAN module is
attached.
• If the output mode is set to
4K Multi streaming
,
4K
25fps
, or
4K 30fps
, it will be automatically switched to
Full HD when the WLAN module is attached. Make sure
to reset the output mode to the original setting after the
WLAN module is removed.
For details on settings, please refer to the User Guide.
• Using devices other than those specified may lead to
faults or malfunctions.
• Use WLAN in an environment with outside temperature
between 0 °C (32 °F) and 40 °C (104 °F).
• If the WLAN module is covered by metal such as
housing while WLAN is being used, the radio wave
reception becomes poor and may not work.
1
2
4
3
5
6
7
8
9
q;
qa
