Ot
he
rs
Using the Supplied Setup Program
28
Note
If the IP address is not set correctly, the welcome page
does not appear after step 12. In that case, try to set the
IP address again.
Changing the Communication
Bandwidth
1
Click the Bandwidth control tab to display the
bandwidth setting window.
The current bandwidth is displayed in
Current
bandwidth
.
2
Click to select the desired bandwidth from the
Setting bandwidth list box.
3
Type the Administrator name and Administrator
password in each box.
4
Click
OK
.
If "Setting OK" is displayed, the bandwidth setting
is completed.
Note
The contents of the bandwidth changed in "IP Setup
Program" are reflected to
Bandwidth control
in the
Network setting page (page 20).
Setting the Date and Time
You can set the date and time on this unit.
1
Click the Date time tab to display the date/time
setting window.
2
Click to select the SNC-DP10 you want to set the
date and time for.
3
Select the date/time format from the Date time
format drop-down list.
4
Select the area where the SNC-DP10 is installed
from the Time zone selecting drop-down list.
5
Set the date and time.
You can set the date and time in two ways.
Manual setting
Set the current date and time on the Manual current
date time setting boxes, and click
OK
. The setting
boxes are for the year (lower two digits), month,
date, hour, minutes and seconds from left to right.
Using the computer’s date and time
The date and time set on the computer is displayed
in the PC current date time setting box.
Click
OK
on the right to set the date and time of
SNC-DP10 to the displayed computer's date and
time.
