Ad
minis
tra
ting t
he Camer
a
Sending an Image via E-mail — SMTP setting Page
25
Sending an Image via E-
mail
— SMTP setting Page
When you click
SMTP
on the Administrator menu, the
SMTP setting page appears.
Use this page to set up for the SMTP function that can
capture and send a still image attached to an E-mail.
Activating/Deactivating the SMTP
Function — SMTP usage setting
Page
To activate the SMTP function, select
Use SMTP
function
and click
OK
. The SMTP setting page
appears.
When you do not use the SMTP function, select
Do not
use SMTP function
and click
OK
.
Note
The frame rate and operability on the main viewer may
decrease while an image file is being transmitted via an
E-mail.
Setting the SMTP Function
— SMTP setting Page
SMTP server name
Type the SMTP server name up to 64 characters, or the
IP address of the SMTP server.
Recipient e-mail address
Type the recipient E-mail address up to 64 characters.
You can specify up to three recipient E-mail addresses.
Administrator e-mail address
Type the Administrator e-mail address up to 64
characters.
This address is used for reply mail and sending error
messages from this unit.
Subject
Type the subject/title of the E-mail up to 64 characters.
Message
Type the text of the E-mail up to 384 characters. (A line
break is equivalent to 2 characters.)
Image file name
Type the basic file name you want to assign to the image
to attach an E-mail. You can use up to 6 alphanumeric,
- (hyphen) and _ (underscore) for naming.
Suffix
Set the suffix to add to the file name.
Select
None
.
Date/Time
and
Sequence number
are not active in this
camera.
Sequence No. clear
It is not active in this camera.
Mode
Set the mode of the SMTP function.
Select
Manual
in the initial setting.
Alarm
and
Periodical sending
are not active in this
camera.
Back/OK
See “Buttons common to every setting page” on page
12.
If you select
Use SMTP function
, the inside fan stops or the
temperature increases more than usually, then a mail is sent
to make this known.
Important
