12
Tuning your TV to the VCR
filename[010get.fm] model name1[SLV-SE250B] model name2[SLV-SE450B]
[3-868-346-E2 (1)]
To check to see if the TV tuning is correct
Set the TV to the video channel and press /– on the VCR. If the TV
screen changes to a different programme each time you press /–, the TV
tuning is correct.
To obtain a clear picture from the VCR
If the screen does not appear clearly in step 6 above, go to step 7 to finish this
procedure once. Then start again from step 2. After pressing REGL CANAL in step
2, press /– while the RF channel is displayed, so that another RF channel
appears. Then tune the TV to the new RF channel so that a clear picture appears.
5
Press /– (repeatedly) to select the appropriate TV system for
your area.
Select “L” for the L TV system (SECAM), or “G” for the B/G TV system
(PAL).
6
Tune the TV to the same channel shown in
the VCR display window so that the
picture on the right appears clearly on the
TV screen.
Refer to your TV manual for TV tuning
instructions.
If you select the wrong TV system in step
5, the picture on the right may not appear.
Select the appropriate TV system and tune
the TV again.
If the picture does not appear clearly, see “To obtain a clear picture from the
VCR” below.
7
Press REGL CANAL.
You have now tuned your TV to the VCR. Whenever you want to play a
tape, set the TV to the video channel.
CHAINE
ALIGNEMENT
MAGNETOSCOPE SONY
REGLAGE AUTO
REGL CANAL
010COV.book Page 12 Friday, April 14, 2000 1:07 PM
