22
GB
Additional Information
Troubleshooting
If you experience any of the following dif
ficulties while
using the player
, use this tr oubleshooting guide to help
you r emedy the pr oblem. Should any pr
oblem persist,
consult your near
est Sony dealer
.
There is no sound.
,
Check that the player is connected secur
ely .
,
Make sur e you operate the amplifier cor
rectly .
There is no sound from the DIGITAL OUT CD
connectors.
,
The audio signals of the super audio CD cannot be
output fr om the DIGIT AL OUT CD connectors.
,
Press DIGIT AL OUT to display “16 bit” in the
display when the player is playing the CD.
The disc does not play.
,
Ther e is no disc inside the player
.
,
Ther e is no stabilizer on the disc.
,
The disc is placed upside down on the tray
.
,
Place the disc on the disc tray with the label side
up.
,
The disc is placed at an angle. Reload the disc and
the stabilizer .
,
Clean the disc (see page 21).
,
Moistur e has condensed inside the player
. Remove
the disc and leave the player turned on for about
an hour (see page 20).
,
Ther e is an incompatible disc on the tray (see page
7).
,
Clean the turntable (see page 21).
The remote does not function.
,
Remove any obstacles in the path of the r
emote
and the player .
,
Point the r emote at the r
emote sensor on the
player .
,
If the batteries in the r
emote ar e weak, r eplace
with new ones.
Specifications
When a super audio CD is played
Playing frequency range
2 Hz to 100 kHz
Frequency response
2 Hz to 50 kHz (–3 dB)
Dynamic range
105 dB or more
Total harmonic distortion rate
0.0012 % or less
Wow and flutter
Value of measurable limit (±0.001 %
W. PEAK) or less
When a CD is played
Frequency response
2 Hz to 20 kHz
Dynamic range
100 dB or more
Total harmonic distortion rate
0.0017 % or less
Wow and flutter
Value of measurable limit (±0.001 %
W. PEAK) or less
Output connector
*Output only the audio signals of the CD
General
Laser radiant power:
1.52uW at 780nm (for CD)
5.47uW at 650nm (for SACD)
*These output is the value measured at a distance of about
200mm from the objective lens surface on the optical pick-up.
Power requirements
European models: 230 V AC, 50/60 Hz
USA and Canadian models:
120 V AC, 60 Hz
Power consumption
36 W
Dimensions (w/h/d)
430
×
149
×
436 mm
(17
×
5
7
/
8
×
17
1
/
4
in.) incl. projecting
parts
Mass (approx.)
25 kg (55 lbs 2 oz.)
Supplied accessories
See page 4.
Design and specifications are subject to change without notice.
Load impedance
ANALOG OUT
DIGITAL OUT
CD OPTICAL*
DIGITAL OUT
CD COAXIAL*
Phono
jacks
Jack type
2 Vrms
(at 50 kilohms)
Square
optical
output
connector
–18 dBm
0.5 Vp-p
Over 10 kilohms
Light emitting
wave length:
660 nm
Output level
75 ohms
Coaxial
output
connector
( )
