HELP
SAL75300 (4.5-5.6/75-300) (75-300mm F4.5-5.6)
4.
Hold the focus barrel block and turn the inner tube block to the position of figure in the direction of the arrow. (The turning is approx.
260 degree, so that the projection goes over about 5 mm from the area for attaching brush.)
Note:
It may stop halfway around the flexible, focus, but keep turning.
5.
Insert the front barrel to the inner tube block until it stops.
6.
With front barrel fitted, turn the inner tube block in the direction of the arrow to engage to helicoid.
7.
When the helicoid stops turning, check that the FPC number is seen from the area for attaching brush.
If you cannot see the number, reassemble again from the step 3.
8.
Attach the focus stopper.
9.
Turn the focus barrel to the both directions (infinity
↔
close), and check that the helicoid moves smoothly.
2 6 8 4
1 6 0 4
Hold the focus barrel block.
Area for attaching
brush
Projection
Turn the inner
tube block.
Approx. 5 mm
2 6 8 4
1 6 0 4
Install until it stops and hold the position.
Front Barrel
Turn the inner
tube block in the
reverse direction.
2nd step
1st step
2 6 8 4
1 6 0 4
2 6 8 4
1 6 0 4
FPC number at the
position of helicoid-end
Area for attaching brush
Focus Stopper
Focus Barrel
