3
3
SA-WM200
SECTION 1
GENERAL
This section is extracted from
instruction manual.
LEVEL
PHASE
POWER
POWER indicator
CUT OFF FREQ
CUT OFF FREQ
200H z
NORMAL
REVERS E
50H z
PHASE
POWER
LEVEL
MIN
MAX
FRONT VIEW
REAR VIEW
• Location of controls
SECTION 2
DIAGRAMS
For Schematic Diagrams.
Note:
• All capacitors are in
µ
F unless otherwise noted. pF:
µµ
F 50 WV or
less are not indicated except for electrolytics and tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise specified.
•
C
: panel designation.
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
For Printed Wiring Boards.
Note :
•
X
: parts extracted from the component side.
•
x
: parts extracted from the conductor side.
•
: Pattern from the side which enables seeing.
• Abbreviation
CND : Canadian model
MY
: Malaysia model
SP
: Singapore model
•
A
: B+ Line.
•
B
: B– Line.
• Voltages are dc with respect to ground under no-signal conditions.
• no mark : Power on
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal production tolerances.
• Signal path
.
F
: AUDIO
• Abbreviation
CND : Canadian model
MY
: Malaysia model
SP
: Singapore model
Note:
The components identi-
fied by mark
0
or dotted
line with mark
0
are criti-
cal for safety.
Replace only with part
number specified.
Note:
Les composants identifiés par
une marque
0
sont critiques
pour la sécurité.
Ne les remplacer que par une
piéce portant le numéro
spécifié.
2-1. CIRCUIT BOARDS LOCATION
SWITCH board
INPUT CONTROL board
MAIN board
POWER TRANS board
CONTROL board
Summary of Contents for SA-WM200
Page 13: ...13 SA WM200 MEMO ...
