26
GB
Adding an Extra
Function to the
Component Select
Buttons
Programming the Power-On
Command of the Selected
Component just by pressing
that Component Select
button (for Sony
Components only)
When using Sony components,
you can program the Power-On
signal for each component on a
Component Select button. You can
select the desired component and
power it on by just pressing that
Component Select button.
Example: To program the TV
button
1
Press SET.
All Component Select buttons
flash.
2
While holding
1
pressed,
press the desired
Component Select button.
When you first press
1
, only
the Component Select buttons
that have already been set with
the Power-On command light
up.
Example: If the Power-On
command has been
programmed on the VCR and
DVD buttons, these buttons
light up when you first press
1
.
To cancel setting, press SET.
To clear the Power-On command
Repeat the same procedure,
pressing the desired Component
Select button that lights up when
you press
1
.
Notes
• If the component code of a non-Sony
brand has been set on a Component
Select button, you cannot programme
the Power-On function on it. If you
change the component code (page 8)
after setting the Power-On function,
the Power-On function is cleared.
• Even if you used the Learning
function (page 15) to programme a
signal on a Component Select button,
you can program the Power-On
function on that button but it cannot
be used. If you clear the “learned”
function on that button, you can use
the Power-On function.
1
2
