17
4
Press P or PROGRAM –
to search component code numbers
in the same category (in this case,
code numbers which begin with “8”).
Press P to go to the next
code number.
Press PROGRAM – to go back to the
previous code number.
Note
To search component code numbers in
another category, return to Step 3, or input
a four-digit component code number of
another category (for example, a code
number which begins with “3”, “4”, etc.)
before Step 4.
5
Aim the Commander at the
component and press the
POWER
1
key.
When the remote control signal is
sent,
is shown on the display.
If it successfully works (power-off for
TV, AMP, playback for CD, MD, DAT,
TAPE and power-on for other
components), go to Step 6.
If it doesn’t, repeat Steps 4 to 5.
6
Press the ENT key.
A beep sounds, and the selected
component name, the preset four-
digit component code number and
“OK” light for 2 seconds. And the
display returns to Step 2.
Note
It is recommended to write down the code
number.
7
Press COMMANDER OFF.
If you keep COMMANDER OFF
pressed for more than 2 seconds
The Commander turns off.
If you keep COMMANDER OFF
pressed for less than 2 seconds
The Commander returns to the
previous set mode.
PROGRAM
COMMANDER
OFF
Summary of Contents for RM-AV3000T
Page 2: ...2 ...
Page 99: ...99 Full Display ...
