113
Se
tti
n
gs an
d Adj
u
st
m
e
n
ts
Input Line System
Selects the colour system when recording
from the connected equipment.
b
Notes
• When picture noise appears after you change the
“Input Line System” setting, change the “Input
Colour System” setting (page 120). If picture
noise still appears, hold down
x
(stop) on the
recorder, and press INPUT on the recorder.
• When you change the “Input Line System”
setting, the Dubbing List is erased.
Power Save
Selects whether this recorder is in power save
mode when the power is turned off (standby).
HELP Setting
Easy Setup (Resetting the Recorder)
Select this to run the “Easy Setup”
programme.
1
Select “Easy Setup” in “Basic,” and press
ENTER.
2
Select “Start,” and press ENTER.
3
Follow the instructions for “Easy Setup”
(page 24) from step 2.
Aerial Reception
Settings (Digital Tuner)
The “Digital Tuner” setup helps you to make
digital tuner and programme position settings
for the recorder.
1
Press SYSTEM MENU while the
recorder is in stop mode.
2
Select “Initial Setup,” and press
ENTER.
3
Select “Digital Tuner,” and press
ENTER.
The “Digital Tuner” setup display
appears with the following options. The
default settings are underlined.
To turn off the display, press SYSTEM
MENU.
NTSC
Records in NTSC or PAL-60
colour system.
PAL/
SECAM
Records in PAL or SECAM
colour system.
Mode 1
Only antenna input signals are
output to the connected TV
when the recorder is in standby.
Mode 2
No input signals are output
when the recorder is in standby.
Off
Does not set to power save
mode. Normally, select this
setting.
On
Displays Help information for
GUI displays.
Off
Does not set to HELP setting
mode.
,
continued