Sony PXW-X160, Operating Manual

Page: 17 / 120

Power Supply 17
P
repa
ra
ti
ons
You can use a battery pack or AC power via an
AC adaptor.
For safety, use only the Sony battery packs and
AC adaptor listed below:
Lithium-ion Battery Pack
BP-U30
BP-U60
BP-U60T
BP-U90
Charger
BC-U1
BC-U2
AC Adaptor (supplied)
ACDP-060S01
Notes
The BC-U1/BC-U2 Charger cannot be used as the
external power source device for the camcorder.
When connecting the camcorder to the wall outlet (wall
socket), use the supplied AC adaptor.
Fully insert the battery pack into the battery pack
receptacle
(page 10) , then slide it down to lock it.
To remove the battery pack, press and hold the
BATT RELEASE button
(page 10) , slide the
battery pack upward to unlock it, then pull it out.
Notes
• Before use, charge the battery pack with the supplied
BC-U1 or BC-U2 Charger.
• A warm battery pack immediately after use may not be
able to be fully recharged.
• The high-capacity BP-U90 Battery Pack is large, and
protrudes from the camcorder when attached. When
using the camcorder with the BP-U90 attached for
extended recording periods, Sony recommends
attaching the camcorder to a tripod for convenience.
Checking battery charge remaining
When recording or playback is in progress on the
battery pack, an icon to show the current battery
charge level and usage time remaining are
displayed on the LCD/viewfinder screen
(page 15) .
The camcorder indicates the remaining usage
time in minutes by calculating the available time
with the battery pack if operation is continued at
the current rate of power consumption.
If the battery charge remaining becomes
low
If the battery charge remaining decreases to a
certain level during operation (Low BATT
status), a low-battery message, flashing of the
recording/tally lamp, and a beep sound will warn
you.
If the battery charge remaining further decreases
to a level at which operation cannot be continued
(BATT Empty status), a battery-empty message
appears.
Replace the battery pack with one that is fully
charged.
To change the message levels
The Low BATT level is set to 10% of full charge,
and the BATT Empty level is set to 3% of full
charge at the factory. These settings can be
changed with “Battery Alarm”
(page 86) in the
System menu.
Preparations
Power Supply
Using a battery pack
Icon Remaining
100% to 91%
90% to 71%
70% to 51%
50% to 31%
30% to 11%
10% to 0%