000
1. Overview
4
Location and Function of Parts
Left Side, Front Side, and Handle
8
9
10
11
12
13
14
15
16
17 18
1
2
3
4
6
5
7
1.
2.
Viewfinder connector (page 15)
3.
4.
INPUT1 (LINE/MIC/MIC+48V) switch
(page 35)
5.
6.
INPUT2 (LINE/MIC/MIC+48V) switch
(page 35)
7.
8.
USB wireless LAN module connector
(page 41)
9.
Flashes when the remaining capacity on the
recording media or battery is low.
10.
Lens lock ring stopper (page 17)
11.
Tape measure hook
The tape measure hook is on the same plane
as the image sensor. To measure the distance
between the camcorder and the subject
accurately, use this hook as a reference point. You
can attach the end of a tape measure to the hook
to measure the distance from the subject.
12.
WB SET (white balance set) button
(page 34)
13.
14.
15.
16.
Handle record START/STOP button
The record button cannot be operated when the
lock lever is in the lock position.
17.
18.
Multi-interface shoe
For details about accessories supported by
the multi-interface shoe, contact your sales
representative.
Attaching the accessory shoe
1
Lift the front edge of the shoe spring, and pull
the spring in the opposite direction to the
arrow engraved on the spring.
Shoe spring
Accessory shoe
1
2
Position the accessory shoe on the accessory
shoe mount, aligning the protrusions on the
shoe with the corresponding points on the
mount, and tighten the four screws.
3
Insert the shoe spring in the direction of the
arrow so that the U-shaped portion fits onto
the end of the accessory shoe.
Shoe spring
Accessory shoe
3
22
