NETWORK RX STATION
PWS-100RX1 / PWS-110RX1 / PWS-110RX1A
Ver.1.11 or later
Setup and Operation Flow
Perform setup and operation in the following sequence to use this system. If using XDCAM air, the unit and transmitting
devices must be registered in XDCAM air beforehand. For details about registering, refer to the XDCAM air Setup Guide.
4-746-464-14(1) Copyright 2015 Sony Corporation
Setup
1
Configure the required network settings to connect the PWS-100RX1 units installed within a broadcasting
station with the camcorders in the field or with XDCAM pocket.
1.
Configuring Connection Control Manager Preferences
Configure the preferences on one PWS-100RX1 unit within the system to function as the Connection Control
Manager.
2.
Register the PWS-100RX1 units that will start Streaming Receiver in the Connection Control Manager using
the Initialization Tool.
3.
Configuring Connection Control Manager Receiver and Output Settings
Launch the Connection Control Manager admin screen, and configure the streaming output settings.
4.
Operation in the field
Setting the Wireless Adapter to Network Client Mode
When shooting using a camcorder with a wireless adapter attached, set the wireless adapter to network client
mode.
Setting the Camcorder to Network Client Mode
When shooting using a network-enabled camcorder, set the camcorder to network client mode.
When using XDCAM pocket, start XDCAM pocket on a smartphone.
2
Operation at the broadcasting station
3
Launching the Connection Control Manager Admin Screen
Log in to the Connection Control Manager from a web browser on a client PC that is connected to the same
network as the PWS-100RX1 that is running the Connection Control Manager.
1.
Start streaming distribution of video received from the camcorder in the field using the Connection Control
Manager.
2.
7
