14
Name and Function of Parts
c
TEMP indicator
If an abnormally high temperature is detected within the
unit, the indicator turns on red.
d
HDD status indicators
If a warning is generated for an HDD, the corresponding
indicator turns on red. The indicator turns off if the
corresponding HDD fails, is in sleep state, or has been
removed.
Rear View
a
SYSTEM TC connector
Not used by this system.
b
Remote connectors (1/2, 3/4, 5)
Not used by this system.
c
AC power supply units
Insert the power cords and connect to power outlets.
Only one AC power supply unit is installed at the factory.
A second optional power supply unit can be installed to
provide power supply redundancy. When used in systems
that require reliability, power supply redundancy allows
the unit to continue operating even if a power supply unit
fails.
For details about installing or replacing a power supply
unit, consult your Sony sales or service representative.
d
SFP+ slot
Attach to an SFP+ module.
e
USB connectors (rear panel)
Connect to drive units using USB cables.
USB devices not described in this document are not
supported.
• Of the four USB connectors on the rear panel, only the bottom right port
supports power delivery (900 mA). The other three ports do not support
power delivery, and should be used to connect USB devices that do not
require power supplied from the USB connector.
• Use SuperSpeed USB cables.
f
LAN connectors
Connect to a Gigabit Ethernet network.
g
HDMI connector
Connect to a monitor using an HDMI cable.
Use only Sony-brand HDMI cables.
Recommended cable (example):
DLC-HE20XF
HIGH SPEED HDMI cable (2 m (6 ft.))
h
DisplayPort connector
Connect to a monitor using a DisplayPort cable.
Use the following recommended cable.
• LINDY 41630 4K-compatible DisplayPort cable (1 m
(3 ft.))
The compatibility of the following displays has been
confirmed.
• ASUS: PB248Q
Use an active-type cable if using a DisplayPort-DVI conversion cable or
DisplayPort-HDMI conversion cable.
LAN1
LAN2
1
1
2
3
4
5
1
1
2
3
5
6
5
7
8
4
Notes
Note
