Viewfinder Screen Display
35
Chapt
er
1
Ov
er
v
ie
w
VF:L-R:
Displays the image obtained by
subtracting the right lens image from the left
lens image, in color.
VF:3D:
Displays a 3D image, in color.
VF:Anaglyph:
Displays an anaglyph.
k
Color temperature
Displays a color temperature calculated from the
gain of R and B, in the range 1.5 K to 50.0 K (in
steps of 0.1 K). The +/– signs may be displayed
depending on the Offset White setting
.
No display:
Offset White is OFF
+:
The value of Offset White is greater than
3200K.
–:
The value of Offset White is less than 3200K.
l
Number of system lines
Indicates the number of system lines (1080/720/
576/480) of video currently being recorded or
played back.
m
Video format
Indicates the format of video being currently
played back or recorded
n
Depth of field indication
Error/warning indication
A bar indicates the depth of field. The display unit
is meters or feet, as selected by OPERATION
>Display On/Off >Length Unit in the setup menu.
An error or warning message is displayed here
depending on the situation.
Under this area, you can also display the name of
the next clip to be recorded
.
o
Special recording mode indication
The following is displayed when the camcorder is
in a special recording mode.
• Frame Rec (Frame Recording mode)
• Interval Rec (Interval Recording mode)
• S&Q Motion (Slow & Quick Motion mode)
p
Special recording mode settings
indication
Appears when the camcorder is in a special
recording mode.
Bottom of viewfinder screen
a
TLCS iris control mode
The following icons are displayed to indicate the
video level control modes based on the Total
Level Control System (TLCS).
b
Focus adjustment mode
Indicates the current focus adjustment mode of
the camcorder.
• AF (Auto Focus mode)
• MF (Manual Focus mode)
• MF* (Manual Focus mode when the MF Assist
function is on)
c
External device control
“REC2” is displayed when MAINTENANCE
>Camera Config >HD-SDI Remote I/F is set to
[Chara] in the setup menu and a recording control
signal is output from the HD/SD SDI OUT
connector.
d
Red tally
Appears when a red tally signal is being input
from the remote control unit connected to the
REMOTE connector. To display this,
MAINTENANCE >Camera Config >Tally Select
must be set to [Remote] in the
setup menu.
Icon
TLCS control mode
Backlight mode
Standard mode
Spotlight mode
STD
STD
Summary of Contents for PMW-TD300
Page 185: ......
