6 (E)
y
⁄
AC IN
REF IN
REMOTE
ROUTING SWITCHER
Location and Function of Parts
8
~AC IN connector
1
Indicator
2
POWER switch
Front panel
Rear panel
7
y
(signal ground) terminal
4
REF IN connector
1
Indicator
Lights in green when this unit is turned on.
Flashes in red in the following cases:
• The temperature inside the unit has risen to a
specified level.
• The ventilation fans have stopped rotating.
• Trouble occurs with the output voltage on the
negative side.
May flash in green in the following cases:
• The rotation of the ventilation fans slows down
drastically.
• Until the rotation of the ventilation fans becomes
stable just after the power is turned on.
2
POWER switch
Turns on and off the power of this unit.
3
Cover plates
Remove the corresponding plates to install the optional
boards.
4
REF IN (reference signal) input connector (BNC
type)
When an optional board such as a BKPF-300-series
board that requires a reference signal input to the PFV-
D10 is installed, input an analog black burst signal as a
reference signal.
POWER
DIGITAL VIDEO INTERFACE UNIT
PFV-D10
I
O
S
3
Cover plates
5
Loop-through output connector
6
REMOTE connector
5
Loop-through output connector (BNC type)
The reference signal input to the REF IN connector is
supplied as it is. When this connector is not used,
connect a 75-ohm terminator.
6
REMOTE connector (BNC type)
For controlling a routing switcher, connect an S-BUS
line when an optional board such as a BKPF-300-
series board that requires an S-BUS protocol input to
the PFV-D10 is installed.
7
y
(signal ground) terminal
For signal ground. Connect to a ground wire as
required.
8
~AC IN connector
Connect to an AC power supply using a power cord
below:
Model available in North America:
DK-2401 AC Power Cord
Model available in the United Kingdom:
Parts No. 1-590-910-11
