35
Preparing the Lens
Cha
p
te
r 2
P
repa
ra
ti
ons
1
Open the iris, position the supplied flange focal length
adjustment chart approximately 3 meters away from
the camera, and arrange the lighting to obtain a
satisfactory video output.
2
Set the ZOOM switch to SERVO (power zoom mode).
3
Hold down the flange focal length adjustment button
for 3 seconds.
The auto focus indicator flashes orange, and the flange
focal length adjustment starts.
During adjustment
The auto focus indicator flashes alternately orange and
green.
The message “AUTO FB EXECUTING
”
appears on
the viewfinder screen.
If the adjustment completes correctly
The auto focus indicator goes off, and the message on
the viewfinder screen changes to “FB: OK
”.
If the flange focal length adjustment does not
complete correctly
The auto focus indicator lights red.
Check the subject and lighting conditions, and repeat
the adjustment.
When using a non-auto focus lens
Read the instruction manual for the lens in use as well.
1
Set the iris to manual.
2
Open the iris, position the supplied flange focal length
adjustment chart approximately 3 meters away from
the camera, and arrange the lighting to obtain a
satisfactory video output.
3
Loosen the fixing screws on the F.f or F.B ring (flange
focal length adjustment ring).
4
Use manual or power zoom to set the lens to telephoto.
5
Point the camera at the chart by turning the focus ring
and focus on the chart.
6
Set the zoom ring to wide angle.
7
Turn the F.f or F.B ring until the chart is in focus,
being careful not to disturb the focus ring.
8
Repeat steps
4
to
7
until the chart stays in focus ring.
9
Tighten the F.f or F.B ring fixing screws.
M
MACRO
A
PUSH
AF
FOCUS
ON
OFF
SERVO
MANU.
ZOOM
T
W
A
M
R
E
T
IRIS
Flange focal length
adjustment button
Auto focus indicator
Zoom ring
Focus ring
ZOOM switch
Summary of Contents for PDW-F355L
Page 189: ...Sony Corporation ...