36
DIP Switch Settings
When performing remote configurations via a network, set all the DIP switches to their OFF (i.e., factory default)
positions.
DIP switch 1
(
: Necessary; –: Not necessary)
1) This setting functions only during manual configuration (via the DIP switches) mode.
Settings for numbers [3] to [5]
Number
Setting
Description
Sender
Receiver
[1]
Operation mode setting
1
Set to ON during manual configuration mode.
[2]
Compression mode
setting
OFF: Transmit compressed images.
ON: Transmit uncompressed images.
Applies only to 4K video formats (4096×2160 / 3840×2160).
[3]-[5]
Input video selection
Select the video input connector to be used during sender mode
(refer to the following section).
–
Video transmission
format setting
Specify the video format that is output to the monitor during
receiver mode (refer to the following section).
–
[6]
System frequency
setting
Configure according to the input video format.
OFF: 59.94 Hz/60 Hz
ON: 50 Hz
–
Output video 3G-SDI
Level B support setting
Configure according to the video format sent from the NU-
IP40S.
OFF: Other than below
ON: Video format from the NU-IP40S is 3G-SDI Level B DS
–
[7]
VGA output setting
1)
OFF: Output at the resolution of the configured video
transmission format.
ON: Output at VGA resolution (640×480) regardless of the
output video downconvert setting.
–
[8]
Output video
downconvert setting
OFF: Output at the resolution of the configured video
transmission format.
ON: Downconvert 4K (4096×2160 / 3840×2160) video to HD
(1920×1080) outputs on the receiver.
–
System
Always set to OFF.
–
Number
Sender (connected to video output device)
input video selection
Receiver (connected to monitor)
video transmission format setting
[3]
[4]
[5]
OFF
OFF
OFF
DVI-D
1920×1080/50i
ON
HDMI
1920×1080/59.94i
ON
OFF
Analog RGB (HD15)
1920×1080/50p
ON
Not used
1920×1080/59.94p
ON
OFF
OFF
Component (RGB)
3840×2160/50p
ON
Component (YCbCr)
3840×2160/59.94p
ON
OFF
VIDEO
4096×2160/50p
ON
S VIDEO
4096×2160/59.94p
