> Connection > Preparing to Control an AV Receiver
Preparing to Control an AV Receiver
If AV Receiver Setup is not completed
If AV Receiver Setup is completed in the Initial Setup, you can control the AV Receiver using the
Keypad.
To control the AV Receiver, press AMP to light up the AMP indicator and activate AV Receiver
control. Point the Keypad to the unit, and use the following keys (keys with orange dots):
(BD/EXT): turns on/off the AV Receiver
INPUT: changes the input of the AV Receiver
VOL: changes the volume up (+) or down (-) of the AV Receiver
MUTING: silences the volume of the AV Receiver
Note
The AMP indicator turns off after 30 seconds, or if you press AMP while the AMP indicator is
on. This ends control of the AV Receiver.
Tip
Press Fn + AMP, the AMP indicator turns on for two seconds. This allows you to continuously
control the AV Receiver using
(ON/STANDBY) /INPUT/VOL. Pressing
(ON/STANDBY) does not turn off the unit.
To return to normal control, press Fn + AMP until the AMP indicator blinks four times.
If AV Receiver Setup is not completed
Connect an IR Blaster to the unit and place it properly on the AV Receiver.
1.
Did You Know
Home
Keypad
Search
Using Applications
Internet
TV
Playback
Preparing to Control an AV
Receiver
Settings
Parts & Controls
Troubleshooting / FAQ
Others
Media Remote
Search
Help Guide
FAQ
NSZ-GT1
61