7
GasLab Q2 displays and operating the device
Page 78 of
135
G a s Q u a l i t y A n a l y z e r
GasLab Q2
7.3.6 Login, logout and change password at operation panel
The login, logout, change password and confirmation or discard of the changes is made on the
“Users Main display”
(accessible via
Home
-
System
-
Users
). The identification and
verification of the user by
user name
and
password
takes place in the device, ie the user must
be already created in the parameterization (see chapter 8) of the device.
Except on the operation panel, you can then login and logout in enSuite.
User management is also accessed via enSuite. For details on user
management, see chapter 8.2
In factory settings the
user name
"SU3" with the necessary rights is preset. The access to the
highest possible rights is managed directly by Elster GmbH. In case of forced access outside of
the rights granted, you will receive a current daily password with additional information from our
support.
An Event log signal is generated for each login.
Only one user can be logged in at the same time! If a user is already logged
in, only one logout is possible via the “U
sers
M
ain display
”
.
The “
Users Main display
” changes its appearance depending on the situation.
See examples in the following figure:
Another user operates an online
parameterization. His name is displayed on top of
the display field. "
Login
" is not possible.
You can "
Logout
" the user (by arrangement).
(Information about parameterization in chapter 8)
A user is already logged in.
His name is displayed on top of the display field.
A new "
Login
" is not possible.
You can "
Logout
" the user (by arrangement).
No user is currently using the device.
Field “
User name
” is preset with the name of the
last user.
The "
Login
" is possible.
Figure 7.56: Login and logout states
Remote operation panel active
This warning is always displayed in the
“Users main display”, when a user is
currently accessing the Q2 via the remote operation panel.
