USO
RESTRITO
76
Independent Key Transitions
Ch
a
p
te
r 3
S
ig
n
a
l S
e
le
c
ti
o
n
and
T
ra
n
s
itio
n
s
Independent key transition/key snapshot control section
LCD buttons
KEY TRANS button
Key delegation buttons
Independent key transition type selection buttons
If the LCD buttons do not appear as the above, you must
press [KEY TRANS] to change their display to the above.
For details about DME wipe settings,
Wipe Setting Operations for Independent Key
Transitions” (p. 119)
3
Execute the transition.
To insert or delete the key gradually with a mix or
wipe transition:
Press one of the [KEY1 TRANS]
to [KEY4 TRANS] buttons.
For details about the transition rate,
Independent Key Transition Rate” (p. 76)
For details about operation together with a common
transition,
“Combining other transitions with
independent key transitions” (p. 74)
To cut the key in or out instantaneously:
Press one
of the [KEY1 ON] to [KEY4 ON] buttons for each
keyer.
Transition control block when connected to MVS-6520/3000A/3000
(ICP-6520/6530 PGM/PST bank)
Notes
For details about PGM/PST block operations when an
ICP-6520/6530 is connected to the MVS-6530,
1
Select one or more of the delegation buttons [KEY1]
to [KEY4] ([DSK1] to [DSK4] in the PGM/PST
bank), turning them on.
You can press more than one button at the same time.
2
Select the transition type.
To fade a key in or out:
Press the [MIX] button,
turning it on.
To insert or delete a key using a dedicated wipe
pattern:
Press the [WIPE] button, turning it on.
To insert or delete a key using a dedicated DME
wipe pattern:
Press the [DME] button, turning it
on.
If, in the Setup menus, you set insertion and deletion
as independent modes, make the following transition
settings.
Separate settings are required for both inserting a key
and deleting it. For example, with the key not inserted,
if you select the transition type and carry out a
transition, this will be the setting when inserting a key.
You can also use the Transition menu to select a
desired independent key transition type for each key.
For details about wipe settings,
Setting Operations for Independent Key Transitions”
(p. 105)
Notes
•
In an independent key transition, the pattern limit
function is not available.
•
When the following DME effects are set, the effects
may be applied during wipe transitions. If the effects
are not necessary, cancel the settings.
-
Trail
-
Motion Decay
When the Keyframe Strobe effect is set, operating
keyframes may produce the same effect. Cancel the
unnecessary DME settings in this case as well.
Copying keys
To copy keys within the same block
Press the [KEY3] button while holding down the [KEY1]
button.
Information for key 1 is copied to key 3.
To copy keys between blocks
Press the [DSK3] button in the PGM/PST bank while
holding down the [KEY1] button in the M/E-1 bank.
Information for key 1 of M/E-1 is copied to key 3 of PGM/
PST.
Setting the Independent Key
Transition Rate
There are two ways of setting the independent key
transition rate: using the Flexi Pad to enter a numeric
value, or using the Misc menu to access the Transition
menu for each switcher bank.
You can also display the transition rate, independent key
transition rate, and fade-to-black transition rate for each
bank, and change the settings
