Sony MKS-6550, User Manual

Page: 426 / 454

USO
RESTRITO
424
Macro File Editing Rules
Event Symbol Using Continue
AUX bus cross-point selection in the cross-point control block AuxXpt No
Cross-point selection in the router RouterXpt Yes
Cross-point selection in the cross-point control block MEXpt Yes
Auto transition and take in the transition control block MEAutoTransition Yes
Cut in the transition control block MECut No
Transition type selection TransitionType No
Next transition setting NextTransition No
Pattern limit on/off PatternLimit No
Fade-to-black execution FadeToBlack No
Auto transition and take in independent key transitions KeyAutoTransition Yes
Key insertion and deletion in independent key transitions KeyCut Yes
Selection of independent key transition type KeyTransitionType No
VTR/DDR/clip start point setting StartTc Yes
VTR/DDR/clip playback Play Yes
VTR/DDR/clip stop Stop Yes
VTR/DDR/clip cue-up Cue Yes
VTR/DDR/clip fast forward FF Yes
VTR/DDR/clip rewind Rewind Yes
Disk recorder/Extended VTR file recall DiskFileLoad No
Recall snapshot Snapshot Yes
A
p
p
e
n
d
ix
File Name
Set the file name as follows.
Example: nnnnnnnn.PNL_rrrr.PMR
nnnnnnnn: In a file created on the switcher, this is a
register name automatically set by the switcher.
The name is limited to eight characters.
The following characters may not be used.
space, \, /, :, ;, , (comma), . (dot), <, >, *, ?, ", |
rrrr: Macro register number (0001 to 0099)
Removable disk Any directory
MACRO
CTRLCPU
nnnnnnnn.PNL_rrrr.PMR
Path example: Removable Disk\Sample\MACRO\
Saving and Recalling a File
For a newly created file, if you create a directory on a
removable disk (see figure below), and move the file to the
prescribed location, you can then recall it in the File >All,
External File menu.
Notes
When amending a file saved on the switcher, be sure to
save it in the original directory.
CTRLCPU\nnnnnnnn.PNL_rrrr.PMR
Errors
If any of the following problems occur, it is not possible to
recall the file. Attempting to recall the file will produce an
error message.
•
If there is a syntax error.
•
If a required parameter is not present.
For details about error messages,
1 “Error Messages”
(p. 434) .
Correspondence between Events and Symbols
For details about events,
1 “Events” (p. 281)
.