37
GB
*1 Not supplied
*2 Speaker impedance: 4 Ω – 8 Ω × 4
*3 RCA pin cord (not supplied)
*4 Depending on the type of car, use an adaptor
for a wired remote control (not supplied). For
details on using the wired remote control, see
“Using the wired remote control” (page 39).
*5 Whether in use or not, route the microphone
input cord such that it does not interfere with
driving operations. Secure the cord with a
clamp, etc., if it is installed around your feet.
*6 For details on installing the microphone, see
“Installing the microphone” (page 39).
*7 Depending on the type of car, use an adaptor
(not supplied) if the antenna (aerial) connector
does not fit.
*8 Use speakers with 50W RMS or higher power
input capacity. Using Sony XB series full range
speakers is recommended.
*9 When the amperage rating of the fuse used on
your car is 10 A, make the power connection to
the battery directly to avoid short circuits.
*10 Before connection, arranging the yellow and
black leads of the power connector is required.
If you have a power antenna (aerial) without
a relay box, connecting this unit with the
supplied power supply lead
may damage
the antenna (aerial).
To the car’s speaker connector
To the car’s power connector
When connecting to the battery directly
When the amperage rating of the fuse used
on your car is 10 A, make the power
connection to the battery directly to avoid
short circuits.
to a metal point of car
to the positive battery terminal
Notes
• Despite connecting to the power supply lead of
the car, the unit may not fully provide its
performance due to insufficient power. In this
case, make the power connection to the battery
directly.
• All power wires connected to the positive battery
post should be fused within 450 mm (18 in) of the
battery post, and before they pass through any
metal.
• Make sure that the car’s battery wires connected
to the car (ground (earth) to chassis)* are of a wire
gauge at least equal to that of the main power
wire connected from the battery to the head unit.
• During full-power operation, a current of more
than 15 A will run through the system. Therefore,
make sure that the wires to be connected to the
+12 V and GND terminals of this unit are at least
14-Gauge (AWG14) or have a sectional area of
more than 2mm² (
3
/
32
in).
If you have any questions or problems
concerning the connection, consult the
dealer for details.
Making connections
1
Rear speaker
(right)
Purple
2
Purple/black
striped
3
Front speaker
(right)
Gray
4
Gray/black
striped
5
Front speaker
(left)
White
6
White/black
striped
7
Rear speaker
(left)
Green
8
Green/black
striped
12
continuous power
supply
Yellow
13
power antenna
(aerial) /power
amplifier control (REM
OUT)
Blue/white
striped
14
switched illumination
power supply
Orange/white
striped
15
switched power
supply
Red
16 ground (earth)
Black
*
Less than 450 mm (18 in)
+12 V car battery
Fuse (15 A)
