19
EN
Notes
• The unit also stands by for traffic
announcements for two hours after you turn off
the engine, as long as the TIR function is on.
• If you have a power aerial, it automatically
extends every time the unit searches for a traffic
programme station.
If you have a manual aerial, make sure that the
aerial is fully extended.
• If you do not use your car for about ten days, the
TIR function will turn off automatically to avoid
battery wear, even if the TIR function is on.
• While the unit is recording or playing back the
traffic announcements, the voice drive function
and voice memo function do not work.
Playing back the recorded traffic
announcements
When there are recorded traffic
announcements you have not listened to yet,
t
flashes.
1
Press
(TIR)
.
The latest traffic announcement is played
back. To listen to the previous ones, press
(TIR)
or push the SEEK/AMS control up.
To replay the announcements, push the
SEEK/AMS control down.
“NO Data” appears if no traffic
announcements were recorded.
2
Press
(TIR)
to return to the original
programme.
2
Press
(5)
(
n
) until the minute digits
flash.
3
Set the minute by rotating the dial.
4
Press
(TIR)
.
5
Select the desired station by pressing the
preset number button or pushing the
SEEK/AMS control up or down.
6
Press
(TIR)
for two seconds to return to
the original display.
t
lights up.
The unit turns on automatically and stands
by for traffic announcements for four hours
(two hours before and after the preset
time).
If the preset station does not broadcast the
traffic announcement while searching, the
unit starts searching for other traffic
programme (TP) stations.
To cancel the TIR function
Select “TIR off” in step 2 above.
Tips
• While the unit is recording the traffic
announcement,
t
and “TA” flash.
• If the unit still cannot find a TP station, it starts a
new search every five minutes until it finds one.
• If you pull out the ignition key while the TIR
function is on, “TIR on” and
t
flash a few times.
RDS
8
REG
REG
