–
20
–
KV
-XA21M80
RM-952
•
REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and
the anode cap to the metal chassis, CRT shield or carbon paint on the
CRT.
•
REMOVING PROCEDURES
1
Do not damage the surface of anode-caps with sharp shaped objects.
2
Do not press the rubber too hard so as not to damage the inside of anode-cap.
A metal fitting called the shatter-hook terminal is built into the rubber.
3
Do not turn the foot of rubber over too hard.
The shatter-hook terminal will stick out or damage the rubber.
•
HOW TO HANDLE AN ANODE-CAP
3
When one side of the rubber cap is separated from the anode button, the anode-cap
can be removed by turning up the rubber cap and pulling it up in the direction of the
arrow
c
.
2
Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow
b
.
1
Turn up one side of the rubber cap in the direction indicated by the arrow
a
.
a
a
b
b
c
Anode Button
2-8. PICTURE TUBE REMOVAL
Note:
•
Please remove necessary CRT support located on top left, top right, prior to removing
the CRT.
@º
@º
!¶
Demagnetic coil
4
Two screws
(washer head)
(+P 4
×
16)
!º
Two screws
(Tapping 7+
Crown Washer)
3
Speaker
(13
×
7cm)
7
Speaker
(15
×
6.5cm)
!£
Tension
spring
!¡
Chassis assy
!¢
Deflection
yoke
!™
C1 board
!ª
Anode
cap
Coating earth assy
!∞
Picture tube
!¢
Cushion
9
Two screws
(Tapping 7+
Crown Washer)
8
Two screws
(washer head)
(+P 4
×
16)
@ª
Holder DGC
Cushion (50x550) DGC
Cushion (50x550) DGC
