36
Manual Programme
Preset
Before selecting “Label”/“AFT”/“Audio Filter”/“Skip”/“Colour System”, press
PROG +/–
to select the programme number with the channel. You cannot
select a programme number that is set to “Skip” (page 36).
“Programme”/“TV System”/“Frequency”
Presets programme channels manually.
1
Select “Programme”, then press
.
2
Press
F
/
f
to select the programme number you want to manually tune
(if tuning a VCR, select channel 0), then press
RETURN
.
3
Press
F
/
f
to select “TV System”, then press
.
4
Press
F
/
f
to go to the frequency range indication (“VHF Low”, “VHF High”
or “UHF”), then press
.
5
Tune the channels as follows:
Press
G
/
g
to search for the next available channel. When a channel has been
found, the search will stop. To continue searching, press
G
/
g
.
Repeat the procedure above to preset other channels manually.
“Label”
Assigns a name of your choice, up to seven letters or numbers, to the selected
channel.
To input characters:
1
Press
F
/
f
to select the desired letter or number (“_” for a blank space),
then press
g
.
If you input a wrong character
Press
G
/
g
to select the wrong character. Then, press
F
/
f
to select the correct
character.
2
Repeat the procedure in step 1 until the name is completed, then press
.
“AFT”
Allows you to fine-tune the selected channel manually. When “On” is selected,
the fine tuning is performed automatically.
“Audio Filter”
Improves the sound of individual channels when distortion occurs in mono
broadcasts in TV system “B/G”, “I” and “D/K”.
• You cannot receive stereo or dual sound when “Low”/“High” is selected.
“Skip”
Skips unused channels when you press
PROG +/–
to select channels. (You
can still select a skipped channel using the number buttons.)
“Colour System”
Selects the colour system (“Auto”, “PAL”, “SECAM”, “NTSC3.58”, “NTSC4.43”
or “PAL60”) according to the channel.
“Signal Level”
Displays the signal level for programme currently being watched.
red
(weak)
yellow
(average)
green
(good)
