A
d
mini
s
tra
ting
t
he
Came
ra
Setting the Camera Image — Camera Menu
44
IR illuminator (SNC-CH160/CH260/DH160/
DH260)
Sync with Day/Night:
IR illuminator will be activated
once Day/Night mode switched, when it is checked.
Off:
IR illuminator will be always off.
Maximum Strength:
From low to high, Maximum
strength for IR illuminator is graded from level1 to
level6.
Washed-out image control (SNC-CH160/CH260/
DH160/DH260)
Setting to prevent image wash-out by the
IR
illuminator
when using night mode.
This feature is activated only when
IR illuminator Sync
with Day/Night
link is selected.
Select
On
to always prevent subjects becoming washed-
out.
OK/Cancel
See “Buttons common to every menu” on page 32.
Video codec Tab
Use this tab to set the items for the video codec.
Cropping
You can crop a portion of the image and display the
cropped image on the computer. Cropping reduces the
transmitting data size and thus the network load, and a
higher frame rate is achieved.
Select
On
to crop the image, or
Off
.
Notes
• The motion detection function is not available when
Cropping
is set to
On
.
• Cropping is not available when SolidPTZ is enabled.
• Video 2 image is cropped with the same setting as
Video 1.
To crop an image
1
Set
Cropping
to
On
and click the
Area setting
button.
The area setting window appears.
2
Setting the trimming portion
Hold down the left button of the mouse on the still
image and drag the cursor diagonally. The area in a red
frame is the trimming portion.
3
Click
OK
at the bottom of the window.
The cropped image is displayed on the main viewer.
4
To close the image, click
in the upper-right
corner.
SolidPTZ
Select
On
to enable the SolidPTZ function.
Notes
• SolidPTZ is not available when Cropping is enabled.
• When
SolidPTZ
is set to
On
, the motion detection
function is not available.
• When
SolidPTZ
of
Image 1
is set to
On
,
SolidPTZ
of
Image 2
can be set to
On
.
• When
SolidPTZ
is set to
On
,
Easy Focus
may not
work properly. In this case, set
SolidPTZ
to
Off
.
Codec
Select
JPEG
,
MPEG4
,
H.264
or
OFF
. Note that Image
1 cannot be set to
Off
.
Notes
• The selectable size of images and frame rate for
Image 2 may be limited depend on the setting of codec
type, size of images and/or frame rate for Image 1.
• Motion detection function is not available when Image
2 is set to other than
Off
.
Image size
You can select the size of images sent from the camera.
The selectable size of images are depend on the setting
of maximum image size. For details on selecting
maximum image size, refer to “Installation tab” in
“System menu” in page 36.
When you set the different image size to Image 1 and
Image 2, the available combinations are as follows:
