Changing the “Frequency” Setting
with the Remote Commander
If the “Frequency” setting in the Video setup menu is configured incorrectly, pictures will not be displayed on
the monitor. In such cases, use the
(power) switch on the unit and the buttons on the Remote Commander
to configure the correct settings.
To change the “Frequency” setting
Wait at least 2 minutes after rebooting the unit, and then perform the following.
Press the
(power) switch on the unit.
Within five seconds after you pressed the
switch, press the buttons on the
Remote Commander as follows, based on the desired “Frequency.”
Desired “Frequency”
On the Remote Commander, press:
60 Hz
VIDEO INPUT button (once)
Number button 1 (three times)
50 Hz
VIDEO INPUT button (once)
Number button 2 (three times)
The “Frequency” setting is changed, and the unit shuts down. Press the
(power) switch on the unit
again to turn it on.
“IPELA” and
are trademarks of Sony Corporation.