Sony ILME-FR7, Help Manual

Page: 246 / 458

Help Guide
Interchangeable Lens Digital Camera
ILME-FR7 / ILME-FR7K
About Streaming
The unit can simultaneously stream the video and audio that is output from the HDMI connector.
Note
To use streaming as the main video, set [Monitoring] > [Output Display] > [SDI] to [On] and [HDMI/Stream] to [Off] in the web
menu, and monitor the camera status on an SDI monitor.
If a monitor connected to the HDMI connector does not support the HDMI output format configured using the [Monitoring] menu in
the web menu or camera menu, the camera image will not be output to the Web App. Streaming video also cannot be output.
The streaming resolution cannot be set higher than the HDMI output signal resolution.
When viewed by multiple users, the image may become distorted depending on the codec settings.
The unit supports the following streaming methods. The video codecs available for selection are shown in parentheses.
RTSP (H.264, H.265)
SRT-Caller (H.264)
SRT-Listener (H.264)
NDI|HX (H.264, H.265)
Configure the streaming format setting, video codec setting, and audio codec setting in that order.
●: Enabled, –: Disabled
Hint
The image in the Web App camera image panel is also a streaming system.
5-041-957-11(1) Copyright 2022 Sony Corporation
Streaming format
Codec setting
Video Stream 1 Video Stream 2 Video Stream 3 Audio Stream
RTSP
●
video 1 ●
video 2
– ●
SRT ● – – ●
NDI|HX
●
Main ●
Sub
– ●
Web App – – ● –
246