HT-MT300/MT301
HT-MT300/MT301
29
29
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
For Printed Wiring Boards.
Note:
•
X
: Parts extracted from the component side.
•
Y
: Parts extracted from the conductor side.
•
: Pattern from the side which enables seeing.
(The other layers’ patterns are not indicated.)
Caution:
Pattern face side:
(Conductor Side)
Parts face side:
(Component Side)
Parts on the pattern face side seen
from the pattern face are indicated.
Parts on the parts face side seen from
the parts face are indicated.
Caution:
Pattern face side:
(SIDE B)
Parts face side:
(SIDE A)
Parts on the pattern face side seen
from the pattern face are indicated.
Parts on the parts face side seen from
the parts face are indicated.
• MAIN board is multi-layer printed board. However, the
patterns of intermediate layers have not been included in
diagrams.
• Indication of transistor.
C
B
These are omitted.
E
Q
For Schematic Diagrams.
Note:
• All capacitors are in
μ
F unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in
Ω
and 1/4 W or less unless otherwise
speci
fi
ed.
•
C
: Panel designation.
•
A
: B+ Line.
• Voltages are dc with respect to ground under no-signal
conditions.
no mark : POWER ON
*
: Impossible to measure
• Voltages are taken with VOM (Input impedance 10 M
).
Voltage variations may be noted due to normal production
tolerances.
• Signal path.
F
:
AUDIO
(ANALOG)
L
:
USB
Note 1:
When the complete MAIN board is replaced, refer
to “NFC CONNECTION CHECKING METHOD”
on page 4, “WIRELESS CONNECTION (LINK)
WORK OF BAR SPEAKER AND SUBWOOFER”
on page 5 and “SPREADING OF COMPOUND” on
page 7.
Note 2:
Among mounted electrical parts on each boards, only
parts that are described in the electrical parts list can
be replaced for repair.
The parts that are not described in the electrical parts
list cannot be replaced with single for repairing.
Note 1:
When the complete MAIN board is replaced, refer
to “NFC CONNECTION CHECKING METHOD”
on page 4, “WIRELESS CONNECTION (LINK)
WORK OF BAR SPEAKER AND SUBWOOFER”
on page 5 and “SPREADING OF COMPOUND” on
page 7.
Note 2:
Among mounted electrical parts on each boards, only
parts that are described in the electrical parts list can
be replaced for repair.
The parts that are not described in the electrical parts
list cannot be replaced with single for repairing.
• Circuit Boards Location
MAIN board
JACK board
TOUCH board
BLUETOOTH MODULE
(BT1)
NFC board
LED_CHUKEI board
• IC Block Diagram
– TOUCH Board –
IC4002 PST8429UL
GND 1
VDD 2
+
–
VREF
OUT
4
CD
3
Summary of Contents for HT-MT300
Page 26: ...MEMO HT MT300 MT301 26 ...
