62
GB
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver’s memory may remedy
the problem (page 23). However, note that all
memorized settings will be reset to their initial
settings and you will have to readjust all
settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
Reference sections for clearing
the receiver’s memory
Specifications
Amplifier section
Models of area code CEL, CEK AU
Power Output
1)
Stereo mode (rated) (6 ohms 1 kHz, THD 1%)
85 W + 85 W
Surround mode
2)
(reference)
(6 ohms 1 kHz, THD 10%)
RMS output
FRONT:133 W
per channel
CENTER: 133 W
SURROUND: 133 W
per channel
Surround mode
2)
(reference)
(6 ohms 100 Hz, THD 10%)
SUB WOOFER: 135 W
1)
Measured under the following conditions:
2)
Reference power output for front, center, surround
speakers and sub woofer. Depending on the sound
field settings and the source, there may be no
sound output.
Inputs
Analog
Sensitivity: 800 mV/
50 kohms
Digital (Coaxial) Impedance: 75 ohms
Tone
Gain levels
±6 dB, 1 dB step
Reproduction frequency range:
28 – 20,000 Hz
FM tuner section
Tuning range
87.5 - 108.0 MHz
Antenna
FM wire antenna
Antenna terminals
75 ohms, unbalanced
Intermediate frequency
10.7 MHz
To clear
See
All memorized settings
Customized sound fields
Area code
Power requirements
CEL, CEK, AU
230 V AC, 50 Hz
