Sony HT-AF5, Operating Instructions Manual

Page: 37 / 80

37 GB
T
u
n
e
r Op
era
tio
ns
1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the subwoofer.
2
Press and hold /–
until the auto scanning starts.
Press to scan from low to
high frequency; press TUNING – to scan
from high to low frequency.
The system stops scanning whenever a
station is received. To stop the Auto
Tuning manually, press /–.
If an FM program is noisy
If an FM program is noisy, you can select
monaural reception. There will be no stereo
effect, but reception will improve.
1
Press MENU/HOME.
2
Press V / v repeatedly until “FM
MODE” appears, then press
or b .
3
Press V / v repeatedly until
“MONO” appears, then press
.
• STEREO: Stereo reception.
• MONO: Monaural reception.
The initial setting is “STEREO”.
4
Press MENU/HOME.
Tip
To improve reception, reorient the supplied
antennas (aerials).
Enter the frequency of a station directly by
using the numeric buttons.
1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the subwoofer.
2
Press D.TUNING.
3
Press and hold SHIFT, then
press the numeric buttons to
enter the frequency.
Example 1: FM 102.50 MHz
Select 1
t 0 t 2 t 5 t 0
Example 2: AM 1,350 kHz
Select 1
t 3 t 5 t 0
If you have tuned in an AM station, adjust
the direction of the AM loop antenna
(aerial) for optimum reception.
4
Press and hold SHIFT, then
press ENTER.
If a wrong frequency is entered
“FM ---.--” or “AM ----” appears and then the
display returns to the current frequency.
If you cannot tune in a station
Make sure you have entered the right
frequency. If not, repeat steps 2 to 4. If you
still cannot tune in a station, the frequency is
not used in your area.
Tuning into a station
automatically (Auto Tuning) Tuning into a station directly
(Direct Tuning)