Sony HKSR-101, Operation Manual, Page: 87 / 128

Chap
te
r
7
SR
Mo
ti
on (Wit
h HKSR-1
02 I
n
s
ta
lled)
87
7-2 Select FPS Function
advances from 0 to 23 frames per second. You can also
review the recording by using simple playback without
checking the slow or quick motion effect.
For more information about simple playback, see “To
perform simple playback without checking motion
effects” (page 87).
Notes
• Audio cannot be recorded normally when SR Motion is
used for shooting.
• When the camera FPS is set to a lower value than the
value set for FPS FORMAT (system frame frequency),
recording to the tape proceeds in starts and stops,
because data is recorded only when a certain amount has
been accumulated in the unit’s internal memory.
To perform simple playback without checking
motion effects
Simple playback allows you to check recorded video in
fewer steps than normal playback. Simple playback does
not use the specified target frame frequency, so it does not
allow you to check slow or quick motion effects.
1
Set the number of frames to shoot on the camera (FPS
value).
2
Start recording. During recording, change the FPS
value as required.
3
Stop recording.
4
While holding the FUNC button down, press the
PLAY button.
This starts a recording review. The unit rewinds the
tape for three seconds and then starts playback of the
scene you have just shot. When playback ends, the unit
enters recording pause mode at the point where
recording ended.
To check more than three seconds earlier
If you hold down the FUNC button while pressing the
PLAY button, the unit rewinds as long as you keep the
buttons held down. If the setting of SERVO >REC
REVIEW in the SYSTEM menu is “Normal”, you can
rewind up to ten seconds. If the setting is “All”, you
can hold down the FUNC button and press the PLAY
button once. The unit will rewind to the start of the
most recently recorded cut and start playback.
To perform separate operation by optical-fiber connection
1
Mount the optional HKSR-101 unit on the SRPC-1.
2
Mount the CA-F101 on the read or top panel of the
camera.
3
Connect the CA-F101 and the SRPC-1 with an optical-
fiber cable.
4
Supply power separately to the camera and the SRPC-
1.
Note
It is not possible to supply power from the SRPC-1 to
the camera, or from the camera to the SRPC-1.
5
Set VIDEO I/O >VA INPUT in the VIDEO Setup
menu to “CAM(Optical)”, and set CAM TYPE to
“Standard”.
Note
When they are connected by an optical-fiber cable, the
F23/F35 and this unit communicate via the cable, allowing
CCU CAMERA
F23/F35 Digital Cinematography Camera
CA-F101 Optical Fiber Camera Adapter
SRW-1 + SRPC-1 + HKSR-101
(optional)
FC2-PD50/PD250 Optical-Fiber Cable (optional)