Chapter 9
Setup Menus
9-4
Chapter 9
Setup Menus
Resetting the menu settings to their
factory default values (menu item B20)
To reset the current active menu settings to their
factory default values, proceed as follows.
1
Perform steps
1
to
3
of the procedure described in
the section “To change the settings of menu items
without sub-items” on page 9-3 to set menu item
B20 RESET SETUP to ON.
The current active menu settings are reset to their
factory default settings.
2
Press the F5 (SET) button again.
This saves the menu settings.
Switching the system frequency (menu
item 013)
To switch the system frequency between 59.94i, 50i,
29.97PsF, 25PsF, 24PsF, 23.98PsF, proceed as
follows.
Notes
• Before carrying out this operation, consult the person
responsible for system installation.
• When the unit is used in 50i, 25PsF mode, analog
tape can only be played back in the simple playback
mode.
• When this unit is put into 24PsF or 23.98PsF mode,
SDI (D1), component, and composite signals are not
output.
1
Perform steps
1
to
3
of the procedure described in
the section “To change the settings of menu items
without sub-items” on page 9-3 to set menu item
013 SYSTEM FREQUENCY SELECT to ON.
The menu display changes to allow switching of
the system frequency between 59.94i, 50i,
29.97PsF, 25PsF, 24PsF, 23.98PsF.
2
Switch the setting, then press the F5 (SET) button.
3
Turn the unit off.
The next time the unit is turned on, it will operate in
the new mode.
Switching the line conversion function
(menu item 018)
This operation is valid in 59.94i, 29.97PsF mode only.
It is not available in other mode.
To change the line conversion (OFF TAPE/1035/1080/
720P), use the following procedure.
Notes
• Consult with the administrator responsible for system
installation before carrying out the following
procedure.
• For the setting of the line conversion (see next item,
“Line conversion mode”), setup menu item 916
ACTIVE LINE 1035 CONVERT MODE is valid in
1035-line mode, and setup menu item 917 ACTIVE
LINE 1080 CONVERT MODE is valid in 1080-line
mode.
1
Perform steps
1
to
3
of the procedure described in
the section “To change the settings of menu items
without sub-items” on page 9-3, to set setup menu
item 018 ACTIVE LINE SELECT to ON.
The menu display changes to allow switching of
the setting for line conversion between OFF TAPE,
1035, 1080, and 720P.
2
Select OFF TAPE, 1035, 1080, or 720P, then press
the F5 (SET) button.
3
Turn the unit off.
The next time the unit is turned on, it will operate in
the new mode.
9-2 Setup Menu Operations