Using the Focus Assist Function
39
Outdoor hood (optional)
When the outdoor hood is too tight to move, or too loose
to fix at a desired position, adjust the coin screws on both
sides of the hood. Turn the screws clockwise to tighten,
and counterclockwise to loosen.
Attaching a Number Plate
Insert the tabs on the sides of the number plate into each
slit in the up-tally lamp.
Using the Focus Assist
Function
For details on menu operations, see “Using the Menu”
on page 42.
COLOR PEAKING Function
When the COLOR PEAKING function is set to “ON,” the
peaking signal is displayed with the colors changed.
1
Set “COLOR PEAKING” to “ON” in the PEAKING
menu.
2
Select the displaying color with “COLOR” in the
PEAKING menu.
3
Adjust the chroma level of the video signal with
“CHROMA” in the PEAKING menu.
When “ORIG” is selected in “COLOR,” the video
signal is displayed in monochrome. The chroma
level of the video signal cannot be adjusted.
Color peaking is a function that extracts the high-
frequency components of the video signal and applies
color to those parts. This may be less effective when noise
components are emphasized by VF DETAIL and
MASTER GAIN settings on the camera side, because
then color is applied to the whole screen.
If you plan to use the color peaking function, it is
recommended that the VF DETAIL and MASTER GAIN
settings on the camera side be set as follows.
• VF DETAIL: OFF, or set to a value that does not
emphasize noise.
• MASTER GAIN: Set to a value near 0 dB.
PEAKING PLUS Function
This function can be used to sharpen the edges of an
image that is specified using the color, area selected, or
both. You can also enhance the edges of the entire image.
This function has no effect on the camera’s video output
signals.
To sharpen edges by specifying the color
1
Press the ASSIGN switch that is assigned the
PEAKING PLUS function to switch to the
PEAKING PLUS mode.
The PEAKING PLUS indicator lights up.
Coin screw (on both sides)
Up-tally lamp
Number plate
(supplied)
Note
