12
1
Slide the viewfinder in the direction of the arrow.
The viewfinder stopper automatically pops down.
2
Loosen the viewfinder left-right positioning ring, slide
the viewfinder side to side to the most convenient
position and tighten the ring. (See
position to the left or right”
below.)
3
Connect the viewfinder cable to the VF connector of
the camera.
Adjusting the viewfinder position
The viewfinder position may be adjusted towards the front and
rear and to the left and right to make it easy to see into it.
To adjust the position to the left or right
1
Loosen the viewfinder left-right positioning ring.
2
Slide the viewfinder left or right to move it into a good
viewing position.
3
Tighten the viewfinder left-right positioning ring.
To adjust the position forward or backward
1
Set the viewfinder front-rear positioning lever to the
unlocked position.
2
Slide the viewfinder towards the front or rear of the
camera to move it into a good viewing position.
3
Set the viewfinder front-rear positioning lever to the
lock position to secure the viewfinder.
Detaching the viewfinder
Loosen the viewfinder left-right positioning ring, pull the
viewfinder stopper, then pull out the viewfinder by sliding it in
the direction opposite to that when attached.
Attaching the Cable Clamp Belt
(Supplied)
You can secure the optical/electrical multi cable or triax cable,
connected to the CCU connector, to the side of the camera by
attaching the supplied cable clamp belt.
1
Insert the belt bracket into hole
A
or
B
of the cable
clamp belt.
2
Peel off the cover seal from the camera as shown in
the following diagram.
3
Secure the cable clamp belt to the camera, using the
two suB3
×
8 screws.
Viewfinder left-right positioning ring
Viewfinder front-rear
positioning lever
A
B
Belt bracket
Cover seal
+B3
×
8 screws
