![background image](http://html.mh-extra.com/html/sony/hdc-3300r/hdc-3300r_operation-manual_400103016.webp)
16
Preparations
The various parts of the lens used in adjusting the flange
focal length are in different positions on different lenses.
Refer to the lens’ operation manual.
Attaching procedure
1
Set the iris control to manual, and open the iris fully.
2
Place a flange focal length adjustment chart
approximately 3 meters from the camera and adjust the
lighting to get an appropriate video output level.
3
Loosen the Ff (flange focal length)
ring lock screw.
4
With either manual or power zoom, set the zoom ring
to telephoto.
5
Aim at the flange focal length adjustment chart and
turn the focus ring to focus the image.
6
Set the zoom ring to wide angle.
7
Turn the Ff ring to bring the chart into focus. Take care
not to move the distance ring.
8
Repeat steps
4
through
7
until the image is in focus at
both telephoto and wide angle.
9
Tighten the Ff ring lock screw.
Attaching a Viewfinder
When the viewfinder is attached, do not leave the camera
with the eyepiece facing the sun. Direct sunlight can enter
through the eyepiece, be focused in the viewfinder and
cause fire.
Attaching a viewfinder
The instructions are made using the HDVF-20A/200/
C30WR/C35W viewfinder as an example.
For details on the viewfinder, refer to the instruction
manual of the viewfinder.
Attaching procedure
1
Slide the viewfinder in the direction of the arrow.
The viewfinder stopper automatically pops down.
2
Loosen the viewfinder left-right positioning ring, slide
the viewfinder side to side to the most convenient
position and tighten the ring.
(See “To adjust the
position to the left or right” below.)
3
Connect the viewfinder cable to the VF connector of
the camera.
4
Connect the microphone cable to the MIC 1 IN
connector of the camera.
Adjusting the viewfinder position
The viewfinder position may be adjusted towards the front
and rear and to the left and right to make it easy to see into
it.
To adjust the position to the left or right
Note
Caution
About 3 meters
(10 ft)
SERIE
S
Viewfinder stopper
MIC 1 IN connector
VF connector
Viewfinder left-right positioning ring