Sony HCD-M100, Service Manual

Page: 27 / 82

27 27
6-2. CIRCUIT BOARDS LOCATION
FRONT SP TERM board
REAR SP TERM board (M300AV)
REAR AMP board (M300AV)
FRONT AMP board
PHONES board
PANEL (L) board
PANEL (R) board
CD MOTOR board
SW board
BD board
DISC SENSOR (S) board
DISC SENSOR (R) board
MAIN board
DOOR LED
board
CASSETE board
LEAF SW board
(not supplied)
TABLE
SENSOR board
PANEL board
DOOR SW board
CD LED board
SUB TRANS board
TRANS board
For schematic diagrams.
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in
Ω
and 1 /
4
W or less unless otherwise
specified.
• % : indicates tolerance.
• f : internal component.
• 2 : nonflammable resistor.
• 1 : fusible resistor.
•
C
: panel designation.
• U : B+ Line.
•
V
: B– Line.
•
H
: adjustment for repair.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
• Circled numbers refer to waveforms.
• Signal path.
F
: FM
g
: VIDEO/MD
E : PB (DECK A)
d : PB (DECK B)
G : REC (DECK B)
J
: CD
c
: CD DIGITAL
THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this necessary note is printed in each
block.)
For printed wiring boards.
Note:
•
X
: parts extracted from the component side.
•
f : internal component.
• b : Pattern from the side which enables seeing.
Note:
The components identi-
fied by mark
0
or dotted
line with mark
0
are criti-
cal for safety.
Replace only with part
number specified.
Note:
Les composants identifiés par
une marque
0 sont critiques
pour la sécurité.
Ne les remplacer que par une
piéce por tant le numéro
spécifié.
C
B
These are omitted.
E
Q
B
These are omitted.
C E