![Sony HCD-HPR90 - Receiver Component For Mini Hi-fi Systems Service Manual Download Page 14](http://html.mh-extra.com/html/sony/hcd-hpr90-receiver-component-for-mini-hi-fi-systems/hcd-hpr90-receiver-component-for-mini-hi-fi-systems_service-manual_395849014.webp)
14
HCD-HPR90/HPR99XM
Checking Location:
+
–
CD board
TP (RFACI)
TP (VC)
oscilloscope
(DC range)
Procedure :
1. Connect oscilloscope to TP (RFACI) and TP (VC) on the CD
board.
2. Press the
I/
1
button to turn the power on, and press
the
Z
button to open the CD disc table.
3. Set disc (YEDS-18) on the tray and press the
CD
u
button
to playback.
4. Confirm that oscilloscope waveform is as shown in the figure
below. (eye pattern)
A good eye pattern means that the diamond shape (
◊
) in the
center of the waveform can be clearly distinguished.
VOLT/DIV: 200 mV
TIME/DIV: 500 ns
level:
0.9
±
0.4 Vp-p
TP
(VC)
TP
(RFACI)
IC201
– CD Board (Conductor Side) –
CD SECTION
Note:
1.
CD Block is basically constructed to operate without adjustment.
2.
Use YEDS-18 disc (3-702-101-01) unless otherwise indicated.
3.
Use an oscilloscope with more than 10 M
Ω
impedance.
4.
Clean the object lens by an applicator with neutral detergent when the
signal level is low than specified value with the following checks.
5.
Check the focus bias check when optical pick-up block is replaced.
FOCUS BIAS CHECK
SECTION 5
ELECTRICAL CHECK
Summary of Contents for HCD-HPR90 - Receiver Component For Mini Hi-fi Systems
Page 68: ...68 HCD HPR90 HPR99XM MEMO ...
Page 79: ...11 HCD HPR90 HPR99XM MEMO ...