81
Addi
tion
al
I
n
fo
rm
at
io
n
5
Remove dust from the inside area where
the eyecup block was attached with a
camera blower, etc.
6
Attach the eyecup block to the
viewfinder, pushing it straight on until it
clicks.
b
Notes
• The eyecup block is a precision part. Do not
disassemble it further.
• Do not touch the lens of the eyecup block.
On charging the pre-installed
rechargeable battery
Your camcorder has a pre-installed
rechargeable battery to retain the date, time,
and other settings even when the POWER
switch is set to OFF (CHG). The pre-
installed rechargeable battery is always
charged while your camcorder is connected
to the wall socket via the AC Adaptor or
while the battery pack is attached. The
rechargeable battery will be fully
discharged in about
3 months
if you do
not use your camcorder at all without the
AC Adaptor connected or the battery pack
attached. Use your camcorder after
charging the pre-installed rechargeable
battery.
However, even if the pre-installed
rechargeable battery is not charged, the
camcorder operation will not be affected as
long as you are not recording the date.
x
Procedures
Connect your camcorder to a wall socket
using the supplied AC Adaptor, and leave it
with the POWER switch set to OFF (CHG)
for more than 24 hours.
To change the battery of the Remote
Commander
1
While pressing on the tab, inset your
fingernail into the slit to pull out the battery
case.
2
Place a new battery with the + side facing
up.
3
Insert the battery case back into the Remote
Commander until it clicks.
b
Notes
• When the lithium battery becomes weak, the
operating distance of the Remote Commander
may shorten, or the Remote Commander may
not function properly. In this case, replace the
battery with a Sony CR2025 lithium battery.
Use of another battery may present a risk of fire
or explosion.
WARNING
Battery may explode if mistreated. Do
not recharge, disassemble or dispose of
in fire.
Tab
Summary of Contents for Handycam DCR-HC47E
Page 95: ......
