Sony Handycam CCD-TR3200E, Service Manual

Page: 120 / 149

5-48E
3-6. ARRANGEMENT DIAGRAM FOR ADJUSTMENT PARTS
VC-195 BOARD (SIDE A)
CN909
CN501
IC202
CN551
IC604
CN911
C085
IC001
IC301
10 1 23 1
1
15
2
16
1 44
132 89
45
88
176
133
1
25
75
51
26 50
100 76
50 1
33 48
16 1
49
64
32
17
1 16
48
33
17
32
64
49
VC-195 BOARD (SIDE B)
IC501
CN910
IC751
1
16
1
12
36
25
13 24
48 37
1 12
36 25
13
24
48
37
3. BPF f0 Adjustment (VC-195 board)
Sets the BPF passing frequency so that the AFM signal can separate
from the playback RF signal properly. If deviated. the mono/stereo
mode will be differentiated incorrectly, and noises and distortions
will increase during high volume playback.
Mode Playback
Signal Alignment tape:
For BPF adjustment
(WR5-11CS)
Measurement Point Audio output terminal left or right
Measuring Instrument distortion meter
Adjustment Page F
Adjustment Address 47
Specified Value The Main and Sub channel distortion
rate should be almost the same
(within
±
1%) and minimum.
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.
2) Set the Hi-Fi sound switch (menu display) to “2”.
3) Select page: F, address: 47, change the data and minimize the
distortion rate.
4) Press the PAUSE button of the adjusting remote commander.
5) Set the Hi-Fi sound switch (menu display) to “1”.
6) Select page: F, address: 47, change the data and minimize the
distortion rate.
7) Press the PAUSE button of the adjusting remote commander.
8) Repeat steps 2) to 7) and set the data of address: 47 so that the
distortions rates when the Hi-Fi sound switch is set to “2” and
set to “1” respectively are almost the same and minimum.
9) Press the PAUSE button of the adjusting remote commander.
11) Select page: 0, address: 01, and set data: 00.
12) Set the Hi-Fi sound switch to “STEREO”.
5-47